SCT DCX model 3200 X3 device for Dodge/Chrysler/Jeep. Can store as many as 10 custom tunes. For most applications, an 87, 89, 91, 93, & 94 octane tune will be included and few applications will include a drag racing tune. Tunes are designed for stock to bolt on modified vehicles. Hemifever Tuning supports 1996 through 2006 SCT supported vehicles. Verify your supported vehicle in the Technical Specs
Here is a walk-through for data logging on the device using the X3.
•Plug in the X3 to the vehicles OBD2 port.
•Scroll down to Data Logging, Press Select.
•Then Scroll down to Setup Monitor, Press Select.
•Config Analog Inputs? Select Yes or No, answering yes will allow you to connect a wideband or any other 0-5V component to the device analog input
•Pick Diesel or Gas, then press select.
•You are now ready to pick the pids.
oSelect them by highlighting them and then pressing select. You’ll notice that an Arrow will show next to the PID once selected.
oYou can select up to 20 Pids. NOTE: Default parameters are generated from a generic list of readable PCM parameters. It is possible that some pids shown will not be log able on your particular vehicle.
•Press Cancel to Exit from the list of Pids.
•This will bring you to a Save Data Configuration Menu.
oSelect – Save OK, Left – Back, Cancel – Exit
•Start Data Logging
oSelect – OK, Cancel – Exit
•A Message will display stating to make sure the vehicle is running, press Select to Start Recording.
•Once The Log has started, you can press LEFT/RIGHT arrows to view additional PIDS.
•Select will Stop Recording.
•Cancel will Exit the Log.
•You can Review this Log using a Computer with Livelink 4.24 or greater installed.
•Once 4.24 is installed and open…
•Then press: File/ Import Data log file from X3/livewire.
•A pop up box appears, Select Datalog0.dat from the list, then Press Ok.
•This will open and display the saved datalog.